GSE Temperature Step transformer 2A, for 2 fans

This GSE controller enables simple control of the performance of two fans (inlet and exhaust) according to temperature . A big advantage is the elimination of increased fan noise at start-up or at lower speeds.

Use the left knob to set the optimal temperature, the right knob to set the hysteresis. You adjust the optimal temperature between 20°-30°C, the hysteresis can be set to 2-8°. The fan speed is controlled on 6 levels.

The intake fan always runs one step later than the exhaust fan , which prevents unwanted odors from escaping. So when the exhaust fan runs on level 1, the draft fan is at 0. When the exhaust fan is switched to level 2, the draft fan is on at 1, and so on.

The probe on the four-meter cable is equipped with a sensitive sensor that can measure the temperature from -55°C to +125°C with an accuracy of 0.5°C. This GSE Temperature step transformer is designed for a current of 2 Amps . It is equipped with a low voltage sensor and thoroughly protected by a waterproof housing with a high degree of protection IP54.

Features GSE Temperature Step transformer 2A, for 2 fans

• current: 2A
• dimensions: 265x300x205mm
• voltage: 230V/50HZ
• degree of protection: IP54
• Temperature/Hysteresis: 20-30°C/2-8°C